1, before using pipe processing equipment manufacturing, be sure to check that everything is normal.

2, in the application process, should strictly implement the requirements of the basic parameters, not overweight, otherwise when the lifting height to width ratio or lifting tons exceed the requirements, the top of the hydraulic cylinder will produce more serious oil leakage.

3, if the remaining oil of the manual pump body is not enough, the N32# gear oil should be added to the pump first, after full consideration to work.

4, please refer to the electric pump manual.

5, the lifting focus should be moderate, effective selection of the primary task of electric bending equipment, the bottom pad, fully consider the road hardness and softness standards, whether the gasket is solid wood, whether the placement is stable, to prevent the sandbag gaiters from sagging or skewering.

6. After the electric pipe bending equipment lifts the lifting objects, the supporting point of the lifting objects should be strengthened immediately with a supporting column. It is strictly prohibited to use electric pipe bending equipment as a support column. For long-term support, use YZL self-locking pipe processing equipment manufacturing.

7, in addition to the high pressure pipe bending equipment should be properly placed, should also use a multi-top separation valve, the load of each electric pipe processing equipment manufacturing should be balanced, and pay attention to maintain the same lifting rate. It is also necessary to consider that the road surface will sag due to uneven net weight to avoid the risk of being skewed by the snatch.

8. When applying, first connect the quick insert connector of the manual pump to the top, then select the parts and tighten the refueling screw on the gasoline pump to work. In order to lower the hydraulic cylinder, loosen the handle of the manual oil pump slightly in the opposite direction, the hydraulic cylinder throws out the support, and the hydraulic cylinder will slowly lower. Otherwise, there is a risk of reducing too quickly.

9, LH hydraulic pressure contraction, can be quickly removed after hoisting, but can not use the connected plastic hose to drive LH hydraulic pipe processing equipment manufacturing.

10, the customer should not exceed the rated value of the travel arrangement, so as not to damage the equipment.

11, in the entire application process, pipe processing equipment manufacturing should be prevented from strong vibration.

12, not suitable for strong acid and alkali, corrosion of steam workplaces.

13, the customer should be regularly maintained according to the application.

pipe processing equipment manufacturing https://www.john-sheng.com/